The procedure to install the hard disk drive, floppy, CD ROM, CD-RW or DVD is the same as follows:
Pellet dislodged drive bay cover (space to drive on the casing)
Enter from the front drive bays with the first set the jumper settings (as master or slave) on the drive.
Adjust the position of screw holes in the drive and chassis retaining screws, then install the drive.
Connect the IDE cable connector to the drive and the connector on the motherboard (the connector is used first primary)
1 samapai Repeat step 4 for each installation drive.
If the IDE cable connected to the du drive jumper settings make sure that the difference of the two first drive set as master and the other as slave.
Secondary IDE connector on the motherboard can be used to connect two additional drives.
Floppy drive is connected to a special connector on the motherboard floppy
Connect the power cable from the power supply to each drive.
Pellet dislodged drive bay cover (space to drive on the casing)
Enter from the front drive bays with the first set the jumper settings (as master or slave) on the drive.
Adjust the position of screw holes in the drive and chassis retaining screws, then install the drive.
Connect the IDE cable connector to the drive and the connector on the motherboard (the connector is used first primary)
1 samapai Repeat step 4 for each installation drive.
If the IDE cable connected to the du drive jumper settings make sure that the difference of the two first drive set as master and the other as slave.
Secondary IDE connector on the motherboard can be used to connect two additional drives.
Floppy drive is connected to a special connector on the motherboard floppy
Connect the power cable from the power supply to each drive.
0 komentar:
Post a Comment